RAM 8.0 BUX II Series Betriebsanweisung PDF herunterladen (Seite 43)

7 Series FPGAs Memory Resources www.xilinx.com 43

UG473 (v1.11) November 12, 2014

Stacked Silicon Interconnect

The block RAM blocks cannot be cascaded across the interposer (SLR boundary). For more

information on stacked silicon interconnect (SSI) technology, see WP380

, Xilinx Stacked

Silicon Interconnect Technology Delivers Breakthrough FPGA Capacity, Bandwidth, and Power

Efficiency.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 85 86

7 Series FPGAs 1
Memory Resources 1
Revision History 2
RCCK_RST 3
RCKC_RST 3
RREC_RST 3
RREM_RST 3
Table of Contents 5
About This Guide 9
Additional Support Resources 10
Block RAM Resources 11
Block RAM Introduction 13
UG473_c1_01_052610 15
Read Operation 16
Write Operation 16
Write Modes 16
NO_CHANGE Mode 17
Conflict Avoidance 18
Optional Output Registers 19
Simple Dual-Port Block RAM 20
Cascadable Block RAM 21
Byte-Wide Write Enable 21
RAMB36E1 TDP mode 36 4 22
RAMB36E1 SDP mode 72 8 22
RAMB18E1 TDP mode 18 2 22
RAMB18E1 SDP mode 36 4 22
Block RAM Library Primitives 23
Block RAM Port Signals 26
Set/Reset 27
Cascade In 29
Block RAM Address Mapping 30
Block RAM Attributes 31
Read Width - READ_WIDTH_[A 33
Avoidance, page 18 34
Considerations 35
Block RAM Applications 37
Block RAM 38
Register 38
Block RAM Timing Model 39
RCCK_REGCE 40
RCKC_REGCE 40
RCKO_DO_REG 40
Clock Event 1 41
Clock Event 2 41
Clock Event 4 41
Stacked Silicon Interconnect 43
Built-in FIFO Support 45
Synchronous FIFO 46
FIFO Primitives 48
UG473_c2_04_052610 49
Standard Mode 51
UG473_c2_05_052610 51
Empty Flag 52
Almost Empty Flag 52
Read Error Flag 52
Full Flag 53
Write Error Flag 53
Almost Full Flag 53
FIFO Timing Characteristics 58
EMPTY Signal 59
RCCK_WREN 60
RCKO_AFULL 60
RCKO_FULL 60
RCKO_WRERR 61
RCCK_RDEN 61
FIFO Applications 64
UG473_c2_11_052610 65
512 x 144 FIFO 66
UG473_c2_12_052610 66
UG473_c2_13_052610 67
Built-in Error Correction 69
ECC Modes 70
UG473_c3_01_052610 71
RAMB36E1 72
UG473_c3_03_052610 73
FIFO36E1 73
ECC Modes of Operation 76
UG473_c3_06_100610 78
UG473_c3_07_070110 78
Standard ECC 79
Standard ECC Write 80
Standard ECC Read 80
Set by Attributes 80
ECC Encode-Only Write 80
ECC Encode-Only Read 81
DO_REG = 0 82
DO_REG = 1 82
Encode-Only ECC Write Timing 83
Encode-Only ECC Read Timing 83
Decode-Only ECC Write Timing 83
Decode-Only ECC Read Timing 83
RCKO_PARITY_ECC 85
RCKO_SBIT_ECC 85
RCKO_SBIT_ECC_REG 85
RCKO_DBIT_ECC 85
RCKO_DBIT_ECC_REG 85

Kommentare zu diesen Handbüchern

Keine Kommentare

RAM 8.0 BUX II Series Betriebsanweisung Seite 43

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Audioverstärker RAM 8.0 BUX II Series