RAM 6000 Technical Information PDF herunterladen (Seite 77)

Software Manual 77

Network Tab

New Destination Address Start (Required): This field is used to hold the starting range of real LAN IP of the destina-

tion device behind this router.

One-to-One NAT Range will perform the same operation as a single One-to-One Rule, but over a range of matched IP

Addresses. The pool defined by the Original IP Start->End, will be matched to the pool defined by New IP Start-> End

(the first Original IP will always translate to the first New IP, the second to the second, etc.). The number of entries in

each pool must match. Both fields can be any valid IP. Neither need to be already present/configured/owned on a local

interface of this device. Ports 1-19 are excluded.

Note: Host Redirect and Service Access rules will apply first, and may prevent certain ports from reaching the New Destination.

New Destination Address End (Required): This field is used to hold the ending range of real LAN IP of the destination

device behind this router.

One-to-One NAT Range will perform the same operation as a single One-to-One rule, but over a range of matched IP

Addresses. The pool defined by the Original IP Start->End, will be matched to the pool defined by New IP Start->End

(the first Original IP will always translate to the first New IP, the second to the second, etc.). The number of entries in

each pool must match. Both fields can be any valid IP. Neither need to be already present/configured/owned on a local

interface of this device. Ports 1-19 are excluded.

Note: Host Redirect and Service Access rules will apply first, and may prevent certain ports from reaching the New Destination.

Select Protocol: Choose the protocol type for this port’s data. Options are TCP, UDP, All.

Source Network via Whitelist: Select a whitelist name for the list of names available in the drop-down list. Whitelists

may be viewed/defined via the Network/Firewall/ACL Rules screen.

• Click on the Finish button. You will be returned to the Masquerade/NAT/DMZ Rules dialog window and the NAT

Rules table will now be populated with the recently entered data.

• To delete an existing rule, select it in the table and click on the Delete button. To edit an existing rule, select it in

the table and click on the Edit button.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 210 211

Keine Kommentare

RAM 6000 Technical Information Seite 77