RAM 6000 Technical Information PDF herunterladen (Seite 61)

Software Manual 61

Network Tab

The IP address should have been provided by your Network Administrator. It must be an address valid for the network

described by the value contained in the Enter Subnet Mask field and must not conflict with any other device on the

target network.

Enter Subnet Mask: Enter the desired Netmask for the interface in the field provided.

Your Network Administrator should be able to provide an appropriate value. This value determines the valid range of

IP addresses allowed in the Enter IP Address field.

• Click on the “Save” button for changes to be saved without activating the interface, the “Apply” button will save

your settings and apply them immediately. To revert to the previous defaults, click on the “Revert” button.

3.4.2.4 IPv6

IPv6 Configuration

Enable IPv6: Selecting YES to this option will enable IPv6 routing for devices behind the router. Router Advertisement

messages will be sent periodically to the specified LAN segment, and Router Solicitations will be responded to on that

LAN segment only. A /64 real routable subclass will be available, based on the range provided by an upstream IPv6

Router on the WAN side. Each IPv6 device behind the router is responsible for its own IPv6 firewalling.

This will not affect Neighbor Discovery nor Solicitation messages. Stateless Address Autoconfiguration (SLAAC) will

also be unaffected. These local link addresses are always available.

A reboot is required after changes to IPv6 Routing configuration.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 210 211

Keine Kommentare

RAM 6000 Technical Information Seite 61