RAM 6000 Technical Information PDF herunterladen (Seite 15)

Software Manual 15

Cellular Configuration

Chapter 2 Cellular Connections

2.1 Cellular Configuration

Cellular connectivity can be obtained through the use of an internal (embedded) RF Module.

Your Red Lion router has an embedded cellular radio that is already detected and configured for the intended carrier. If you

are using a carrier that supports the use of an APN, you may have to set your specific APN manually, as covered in the next

section. For GSM and LTE service, carriers may provide custom APNs for static IP addresses of VPNs scenarios depending

on the type of account.

CDMA carriers such as Verizon and Sprint 3G do not rely on a SIM card and are activated over the air. See the Cellular Pro-

visioning section of the manual for more details on CDMA OTA activations.

Embedded modules for CDMA (Sprint / Verizon) should activate automatically over the air once they are powered on and

connected to an antenna. This of course is after you contact your carrier and have an account enabled and connected to

the embedded module by providing the ESN / MEID number from the module to your carrier. This is how the carrier will

tie your account to the internal cellular radio. For some CDMA based 1xRTT internal modules and Sprint Data-Link connec-

tions, additional configuration must be set in the Provisioning screen, detailed later.

Navigate through the Web UI menu to Networking  Cellular Connection  Configuration screen shown in section 2.1.1.

GSM based carriers, such as AT&T, Bell Mobility and Telus will require a SIM card be inserted into the unit and an APN code

to be entered to confirm you are the verified user of that SIM. Be sure to only insert and remove the SIM card while the

unit is powered off.

You can verify your cellular connectivity by viewing the Status Summary page of the web UI screen and observe if the Cel-

lular Interface status shows an IP Address. On the Home screen you should see: Interface, Activation, Connection, IP

Address and Signal Strength. If you do not see an IP Address get populated for the PPP interface you may have an issue

with your settings or your account has not been correctly activated.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 210 211

Keine Kommentare

RAM 6000 Technical Information Seite 15