RAM 6000 Technical Information PDF herunterladen (Seite 141)

Software Manual 141

Automation Tab

Enable Unsolicited Responses: Select if the DNP Slave should send unsolicited messages to the DNP Master. If this

selection is checked, then the user should also configure the following:

DNP Address to Send Unsolicited Messages to: The address of the station to which DNP Slave will send unsolicited mes-

sages in the DNP Address to Send Unsolicited Messages field.

Event Report Queue Timeout (ms): The amount of time in milliseconds any event will be allowed to remain in the event

queue before being reported in the Event Report Queue Timeout field. Minimum value: 1,000 ms (1 second), maximum

value: 3,600,000 ms (1 hour).

Event Report Queue Threshold (events): The minimum number of events in the event queue required to trigger the gen-

eration of an unsolicited even report message in the Event Report Queue Threshold field.

Max. number of events to send in an unsolicited response: The maximum number of events to send in every unsolicited

message.

Note: When planning on using unsolicited responses, there must be at least one DNP object configured to generate

events on any of the three DNP event classes, or else, no events will be generated and thus no unsolicited responses at all

will be generated by the station.

Enable Auto Detection Rate: Check this box to automatically set the detection rate.

Enable Max. time events in queue after disconnect (TCP Server only): Click to enable.

Enable Real Time Data Trace: The DNP3 Slave Driver can be configured to generate real time traces of every Master-

Slave DNP3 transaction for diagnosis and debugging purposes. The real time communication data traces can be

enabled/disabled at any time. The output will be directed to a text file within the file system for later upload. When

your trace scenario is complete, simply run a gatherstats to automatically include this DNP3 trace. Then contact Sup-

port with your results.

Time Synchronization: The station can be configured to request Time Synchronization from the DNP V3.00 Master.

Requests can be configured to be made at intervals of once per minute, once per hour, once per day or never.

• Click on the “Save” button to save your configuration. The “Apply” button will save your settings and apply them

immediately. To revert to the previous defaults, click on the “Revert” button.

(Navigation buttons across the bottom of the DNP3 screen match the selections made from the drop down tab menu.)

1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 210 211

Keine Kommentare

RAM 6000 Technical Information Seite 141