RAM 6000 Technical Information PDF herunterladen (Seite 57)

Software Manual 57

Network Tab

• Click on the Finish button and you will be directed to the Ethernet Interface dialog window and the Interface

Aliases table will be populated with the entered data.

Reboot: Will restart the system and apply all the settings upon reboot.

Revert: Will revert the settings in the dialog window back to the previous saved settings.

Save: The interface will not be activated or deactivated until the device is rebooted. This allows for other configuration

changes to be made to the device which can be committed at a later time.

Apply: The current settings will be saved and the interface will either be activated or deactivated immediately. If the

interface was already active, then it will be deactivate and reactivated using the configured settings just saved. If you

were connected to the Web UI via this interface, an attempt will be made to re-connect to it using the new settings,

when possible.

Applying new settings to the interface may result in disconnection, requiring reconnection using alternate methods.

Incomplete or incorrect network settings could render the device incommunicable and may require being able to connect

either to the device directly or via the network to which it is attached.

Note: To work with the eth1 Interface, follow the steps documented for eth0.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 210 211

Keine Kommentare

RAM 6000 Technical Information Seite 57