RAM 4000 Bedienerhandbuch PDF herunterladen (Seite 13)

III Operating Instruction

In order to ensure successful daily operation of the RAM 4000

vending machine, the owner should operate the machine per the

following instructions: Run every driver once by pressing "sale

test"on the remote, then “set start” to ensure the motors are on their

correct initial positions .

Then check the position of the augors to make sure they can

reach the following standards:

1.SINGLE AUGERS:

A). When the width of the snack is less than the inner diameter

of the augers and bigger than 1.9 in., the front end of the

augers should be at the lowest position of the tray.(A little to

the left as shown in Picture I)

B). When the width of the snack is no less than the inner

diameter of the augers, the front end of the augers should be

turned 1/8 clockwise on the basis of 1).(As shown in Picture

C). When the width of the snack is no bigger than 1.9in., the

front end of the augers should be turn 1/8 counter-

clockwise on the basis of 1).(As shown in Picture I)

If the initial position of the augors cannot reach the above

standards,please adjust it as the following steps:

1. Pull out the chuck of the augors and adjust the angle (As shown in

Picture II) until the front end of the augors can reach the above

standards.

2. Put the drivers to their original positions. Please make sure the

augors line up with the chuck.

Picture II

Picture I

Initial position 1

Initial position 3

Initial position 2

Double augors

Initial position

for beverage tray

Initial position

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 49 50

Keine Kommentare

RAM 4000 Bedienerhandbuch Seite 13