RAM V-6000 Bedienungsanleitung PDF herunterladen (Seite 12)

Modification reserved • 19, rue de Rennes • BP 83221 • F - 35690 ACIGNÉ

This kit converts your MANUBAL unit into a round wrapped bale

grab. The conversion is very simple and is accomplished in just

a few seconds.

Wrapped bale grab opening / closing adjustment

The adjustment is carried out using the holes provided for round

wrapped bales.

7.1 Position the MANUBAL bale grab upright.

7.2 Open the grab halfway. Lower the MANUBAL bale grab

to the ground. Stop the engine.

7.3 Remove the clip from the rod-end ram pin and remove

the pin.

Note: the screw on the pin flat acts to prevent rotation

and need not be removed.

7.4 Position the ram opposite the hole for the wrapped bale

setting. See drawing .

7.5 Insert the pin as well as the synchronising link in the

appropriate hole.

Note: check the spacers for correct positioning.

7.6 Refit the clip.

7.7 Repeat operations 7.3 to 7.6 for the cylinder-end ram

pin.

CAUTION: the synchronising links should be removed from the

MANUBAL bale grab when it is used for wrapped bales, which

allows the 2 grab arms to float. This enhances effectiveness and

safety when stacking bales contiguously.

7.8 Position the first side of the wrapped bale grab kit

(U-section) against the grab tine carrier.

7.9 Position the other side of the wrapped bale grab kit

(O-section) opposite the hole provided for this purpose

in the MANUBAL grab.

7.10 Insert the pin and the clip supplied in the kit.

7.11 Repeat operations 7.8 to 7.10 for the other kit.

Note: the kit is not handed as regards assembly. It is

identical for the left and right-hand sides.

* Option available on MANUBAL V40, V50, W500.

7. WRAPPED BALE GRAB KIT*

515755

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Keine Kommentare

RAM V-6000 Bedienungsanleitung Seite 12