RAM 2000 Betriebsanweisung PDF herunterladen (Seite 18)

Because the data will be available over the Internet and are

stored indefinitely, it is not necessary to log the data. However,

you may still want to log the data for backup or in case the

satellite system has technical problems. If so, refer to the

Logging Data

section for instructions.

To ensure proper functioning of the remote satellite telemetry

system, the DataRAM must be set to average data every 10

seconds. To do this from the ‘MAIN MENU 1’ screen, press the

button beside ‘Parameters’. Set ‘AvgTime’ to 10 seconds.

14:02:19 01 Oct

PARAMETERS 1

AvgTime: 10sec>

LogData: ON>

Every : 00:05:00>

ClearData >

Tag# 1>

Next Screen >

Press ‘EXIT’ to go back to ‘MAIN MENU 1’.

Note: Logging data without the telemetry unit requires ‘Every’

to be set at ‘00:05:00’. Refer to the

Logging Data

section.

DataRAM Configuration

for the Telemetry Unit

To begin sending data to start a run, press the key next to

‘Run (zeroed?)’.

14:02:19 01 Oct

MAIN MENU 1

RUN (zeroed?) >

System Diagnos >

Parameters >

Purge >

Zero >

Next Screen >

The ‘(zeroed?)’ is to remind you that the instrument needs to

be zeroed before every run.

The system will begin sending data after about 1 hour. Within

2 hours, the data will be posted on the Internet site. The data

will be updated hourly.

Sending Data to the

Internet Site

1 2 ... 13 14 15 16 17 18 19 20 21

Keine Kommentare

RAM 2000 Betriebsanweisung Seite 18