RAM 2000 Betriebsanweisung PDF herunterladen (Seite 17)

•

Open the remote satellite telemetry briefcase (figure 6) and

remove the pouch containing the required cables.

• Remove the satellite antenna in the top of the briefcase by

slowly threading it through the retaining clips.

•Screw the antenna into its magnetic base and attach the

base’s cable to the briefcase. The base of the antenna

should be at least 3 feet off the ground for best results.

•Attach the serial cable to the RS-232 port on the back of the

DataRAM and to the serial connection on the briefcase.

•Attach the power cord to the three-prong connector on the

side of the briefcase and plug the cord into a 110-volt power

outlet.

• Ensure that all battery connections are snugly attached to

the battery terminals.

•

Tu rn on the power switch inside the briefcase. The red light

should illuminate.

DataRAM and Remote Telemetry Setup

Figure 6—DataRAM connected to the telemetry unit.

1 2 ... 12 13 14 15 16 17 18 19 20 21

Keine Kommentare

RAM 2000 Betriebsanweisung Seite 17