RAM 6000V Bedienungsanleitung PDF herunterladen (Seite 75)

65 Chapter 5

6. Monitor Stream/ Adam5000 Event Data - ADAM-6000 modules

support Data Stream function. You can define the Host (such as a

PC) by IP. Then ADAM-6000 modules will periodically send its I/

O status to the Host. The IP and period to transfer data is config-

ured in the Stream tab of Status Display area. The configuration

tab will be introduced in Section 5.3.2.

7. Monitor Peer-to-Peer (Event Trigger) - ADAM-6000 modules with

Peer-to-Peer function can play as Event Trigger function. Refer to

Section 5.3.4 for more information. You can choose this option to

receive message from ADAM-6000 module which is enabled Peer-

to-Peer (Event Trigger) function.

8. Monitor GCL IO Data Message - ADAM-6000 modules with GCL

function can play as a standalone controller. Users can define logic

rules and run the rules on ADAM-6000 module. User can define

the logic rule to send out message, depending on the logic condi-

tion, to the Host defined by IP. Refer to Chapter 7 for more infor-

mation about GCL. You can choose this option to receive I/O data

message from ADAM-6000 module which is enabled GCL func-

tion.

Setup Menu:

1. Favorite Group - You can configure your favorite group including

add one new device, modify or delete one current device, sort cur-

rent devices and diagnose connection to one device.

2. Refresh COM and LAN node - ADAM.NET utility will refresh the

serial and LAN network connection situation.

3. Add COM Port Tree Nodes - This option is used to add serial COM

ports in ADAM.NET Utility. You won't need to use this option for

ADAM-6000 modules.

4. Show TreeView - Check this option to display the Module Tree

Display area.

Note: When you enable GCL function, Data Stream function will

automatically be disabled until you disable GLC function.

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 271 272

Keine Kommentare

RAM 6000V Bedienungsanleitung Seite 75